install

■ Hardware setup

<PC version>

Start up your PC and insert the PC version of the floppy disk into the floppy drive.
Be sure to read [README.DOC] in the root directory of the FD first. The installation method is described.

<SUN version>

Get your tape device ready.

<HP version>

Get ready for DAT.

■ Media

Release 2 is available in the following media respectively.

---------------------------
PC version	FD
SUN version	8mm tape
HP version	DAT
---------------------------

■ How to install

<PC version>

In the PC version, it can be installed for each library and tool.
Insert the floppy disk into the software library floppy drive and execute the [INSTALL] command. Install in the current directory. Install all libraries in a directory called [SATURN] in the current directory. If the [SATURN] directory does not exist, create it.
If the floppy drive is A drive and the installation destination is C drive, it will be as follows.

C: \ USR> A: INSTALL [RET]
       ~~~~~~~~~~~~~~

A directory called [C: \ USR \ SATURN \ ....] will be created.

C: \ USR> is the DOS prompt.

CD tool installation

Insert the floppy disk into the floppy drive and execute the [install] command. Install in the current directory. If the floppy drive is A drive and the installation destination is C drive, it will be as follows.

C: \ BIN> a: install [RET]
       ~~~~~~~~~~~~~~

-Specify the [-vcd] option when installing a virtual CD.

C: \ BIN> a: install -vcd [RET]
       ~~~~~~~~~~~~~~~~~~~

-When installing DXFT03DT, it is a self-extracting compressed file, so change the current directory to the installation destination and execute it.

C: \ BIN> a: \ saturn \ segabin \ dxfto3dt [RET]
       ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

The [DXFT03DT \] directory is created. (See the directory structure in [README.DOC])

<SUN version>

Libraries and tools are installed at once.

(1)

Change the current directory to the directory where you want to install it.

(2)

If you select [tar xvf 8mm tape special file], the following [SATURN] directory will be created.

(example)
tar xvf / dev / nrst [RET]
~~~~~~~~~~~~~~~~~~~~~

<HP version>

Libraries and tools are installed at once.

1. Insert the cartridge tape into the device.

2. Move the current directory to the directory you want to install (for example, / usr / bin).

3. Execute the following command.

C: \ BIN> a: install -vcd [RET]
       ~~~~~~~~~~~~~~~~~~~

4. After reading from the tape, the [SATURN] directory and below are created.

caution

Do not change the time stamp as the time stamp is specified to identify the version of each file.
Be sure to read the additional documentation in the [README.DOC] and [\ MAN \] directories for each directory.