<38/54> VDP1 User's Manual /

▲ Back ｜ Forward ▼

VDP1 User's Manual / Chapter 6 Command Table

■ 6.6 CMD SIZE (character size)

CMDSIZE specifies the size of the defined character pattern. CMDSIZE is valid for texture drawing commands. Specify 16 bits at the start address + 0AH of the command table. Set unused bits to 0.

15 14 13 12 11 Ten 9 8 7 6 5 4 3 2 1 0 CMDSIZE + 0AH 0 0 Character size X / 8 Character size Y

Specify the size of the character pattern in multiples of 8 for horizontal (X) and 1 pixel for vertical (Y).
The width is 5 bits, and you can specify a value from 1 to 63. Since it is in units of 8 pixels, you can specify a size of 8 to 504 pixels for the actual size. Do not specify 0.
The vertical is 8 bits, and you can specify a value from 1 to 255. Do not specify 0.
Figure 6.19 CMDSIZE
Horizontal size: 8 to 504 pixels　 ├──────────────┤　 ┏━━━━━━━━━━━━━━┓┬　 ┃ ┃ │　 ┃ ┃ │　 ┃ ┃ │ Vertical size: 1 to 255 pixels ┃ ┃ │　 ┃ ┃ │　 ┃ ┃ │　 ┗━━━━━━━━━━━━━━┛┴　
The relationship between the value defined in the command table and the number of drawing pixels is as follows.

Table 6.5 Relationship between setting values and drawing pixels

Horizontal (X) direction		Vertical (Y) direction
Command table Setting value to	Actually drawn Number of pixels	Command table Setting value to	Actually drawn Number of pixels
0	Setting prohibited	0	Setting prohibited
1	8	1	1
2	16	2	2
:	:	:	:
63	504	255	255

▲ Back ｜ Forward ▼

★ HARDWARE Manual ★ VDP1 User's Manual

	15	14	13	12	11	Ten	9	8	7	6	5	4	3	2	1	0
CMDSIZE + 0AH	0	0	Character size X / 8						Character size Y