8. About MIDI format

MIDI message correspondence table

	STATUS BYTE	Presence or absence of correspondence
NOTE OFF	0x8n + MIDI Channel	○
NOTE ON	8x9n + MIDI Channel	○
POLIPHONIC KEY PRESSURE	0xAn + MIDI Channel	----
CONTROL CHANGE	0xBn + MIDI Channel	○
PROGRAM PRESSURE	0xCn + MIDI Channel	○
CHANNEL PRESSURE	0xDn + MIDI Channel	----
PITCH WHEEL CHANGE	0xEn + MIDI Channel	○
EXCLUSIVE CHANGE	0xF0	----
QUATER FRAME CHANGE	0xF1	----
SONG POSITION POINTER	0xF2	----
SONG SELECT	0xF3	----
TUNE REQUEST	0xF6	----
END OF EXCLUSIVE	0xF7	----
TIMING CLOCK	0xF8	----
START	0xFA	----
CONTINUE	0xFB	----
STOP	0xFC	----
ACTIVE SENCING	0xFE	----
SYSTEM RESET	0xFF	----

Control change correspondence table

Dec Dec	Hex	FUNCTION	○ is supported, △ is special processing, ---- is not supported.
1	01 01	Modulation Depth	○
2	02 02	Bleath Control	○ However, it works in the same way as Expression.
Four	04	Foot Control	----
Five	05 05	Portament Time	----
6	06 06	Data Entry	----
7	07 07	Main Volume	○
8	08 08	Balance Control	----
Ten	0A	Panpot	○
11	0B	Expression	○
12	0C		△ Control for racing games 1.
13	0D		△ Control for racing games 2.
31	1F		△ Special processing for sequence data (* Note).
32	20		△ Bank change.
64	40	Hold 1 (Damper)	○
65	41	Portament	----
66	42	Sostenute	----
67	43	Soft Pedal	----
68	44	Hold 2 (Freeze)	----
80	50		△ Specify the Qsound position (1-4 for 4ch MIDI channel, 1-8 for 8ch).
81	51		△ YAMAHA 3D Control Direction designation.
82	52		△ YAMAHA 3D Control Distance specification.
83	53		△ YAMAHA 3D Control Height specification.
91	5B	Effect Depth	△ Used as an effect change.
92	5C	Tremolo Depth	----
93	5D	Chorus Depth	----
94	5E	Seleste Depth	----
95	5F	Phaser Depth	----
96	60	Data Increment	----
97	61	Data Decrement	----
98	62	LSB of NRPN	----
99	63	MSB of NRPN	----
100	64	LSB of RPN	----
101	65	MSB of RPN	----
120	78 78		△ Stop all sequences (1.33 or later is not supported).
122	7A	Local COntrol	----
one two Three	7B	All Note Off	○ Can be used during development. However, it should not be incorporated into the game.
124	7C	OMNI off	----
125	7D	OMNI on	----
126	7E	Mono mode on	----
127	7F	Poly mode on	----

* Note: Treat as a loop point for sequence data when decompressing the data compressed by the converter. Therefore, even if you send this command directly, it will not be executed.