To replace the interleaved file, you need to recreate the disk image file.
The subheader information of the added / replaced file has the following settings.
Table 8.1 Subheader information for added / replaced files
Item
Setting contents
File number
0
Channel number
0
Submode
For Form1 sector: DATA bit = 1 For Form2 sector: FORM bit = 1, AUDIO bit = 1
Coding information
0
When a CD-DA track is added, the track number changes. Therefore, when playing a CD with the track number specified, it is necessary to change the track number of the CD playback parameter as well.
When using the stream system library, the playback order changes if you add a part of the stream that belongs to the same stream group. To avoid this, add all streams that belong to the stream group.
When adding, you can use up to 1024 subdirectories.
You can specify up to 1024 subcommands when adding differences.
INTERNAL CACHE BLOCK represents the internal cache capacity of ADDCDW, and 16384 bytes is one block. By default, EMS is used to allocate to extended memory. If EMS is not available, use conventional memory.
Index information in the track is ignored on debug discs. (Index 2 and later are collectively regarded as index 1)
Multi-volume is not supported.
On-the-fly writing is not supported in master mode.
On-the-fly writing does not support disks containing secondary volume descriptors and boot record descriptors.
On-the-fly writing does not support discs that are submode controlled by the "Trigger" and "Eors" commands of the CD builder.
A buffer underrun error may occur when writing at 4x speed on Windows95 (DOS window). By setting the operating conditions as follows, the frequency of error occurrence can be reduced.
Do not connect to the network.
Turn off the property "Auto Insert" of the CD-ROM drive in "Device Manager". Especially when using CDR400, be sure to set the CDR400 property "Auto Insert" to OFF. ("Device Manager" is set in "System" of "Control Panel")
Set the DOS window to "full screen view".
End other tasks.
If you cannot write at 4x speed even after making these settings, slow down the writing speed or start the program in MS-DOS mode to deal with it.
